Problems with Drip Irrigation
Whether in a garden center or a home landscape, hand watering each individual plant based on its needs that day is probably the best way to water. By hand watering, you are forced to get up close to each plant; therefore, you’re able to adjust each plant’s watering to its specific need. You can give a dry, wilting plant extra water or skip a plant that prefers to stay on the dryer side. Most of us just don’t have the time for this slow, thorough watering process. Sprinkler or drip irrigation systems allow you to save time by watering large areas of plants all at once. However, sprinklers don’t consider individual plant watering needs; for example, the sprinkler that keeps your lawn lush and green is probably not providing trees and shrubs in the area with the deep watering they need to develop strong, deep roots. Turf grasses have different root structures and watering needs than larger plants. Also, sprinklers often get more water on the foliage than in the root zone. Wet foliage can cause pest and fungal problems, like black spot and powdery mildew.
Drip irrigation systems water individual plants directly at their root zone, eliminating a lot of fungal issues and wasted water. However, these drip irrigation systems still water every plant the same, regardless of individual needs.
Drip irrigation can also be an unsightly mess of hoses and tubes running throughout the garden. These hoses can get clogged by debris, salt build up, and algae, so if they are covered and hidden by mulch, it’s hard to check if they are running properly and fix any clogs. Hoses that are exposed can be damaged by rabbits, pets, children, or gardening tools. I have replaced many hoses that were chewed on by rabbits. When the black hoses of drip irrigation systems are left exposed to the sun, they can heat up the water and basically cook the plants roots.
Drip Irrigation Tips
Rainbird and other companies that specialize in drip irrigation systems have all sorts of special solutions for drip irrigation problems. They have timers that can be set so even if you’re away, you can trust that your plants have been watered. They have different nozzles that can control water flow so that plants like succulents can get less water, while plants with higher water needs can get more. They have sensors that tell the system if it’s raining out so it will not run. They also have sensors that tell the system if water is pooling up around the nozzles. However, most people will start out with a less expensive, basic drip irrigation system. Drip irrigation systems can help you water tough areas, like slopes where run off and erosion can happen from other watering methods. Drip irrigation can be set to give these areas a slow penetrating soak, or can be set to deliver water in bursts that can be soaked in before the next burst. Most problems with drip irrigation come from improper installation or not using the right kind of drip irrigation for the site. Do your homework when choosing a drip irrigation system beforehand and future issues can be avoided.